How to Make a Circle Bead Bracelet
- 1). Wrap the metal around your wrist while its still on the spool. Place two of your fingers underneath the wire under or above your wrist, below the wire. This will ensure the bracelet isn't too tight. Hold a spot where the ends meet so you have a length. Mark it with tape or a marker. Add an inch to that measurement and cut the wire with the wire cutters.
- 2). Take the pliers and bend on end of wire about a quarter of an inch down. Make it so the end touches the wire and creates a small loop. Wrap the end of the wire around the main part of the wire once or twice if you can. This may have to be done with the pliers. Open a jump ring clasp and put it through the small loop. Close the jump ring clasp tightly with the pliers.
- 3). Put the beads onto the wire in the order or pattern you wish. Slide them on one at a time. Once you have them all on, test putting the bracelet around your wrist again, to be sure that it looks and fits as needed. After you are satisfied tie a rubber band on the wire where the last bead is. This will prevent the beads from rolling off the wire.
- 4). Take the end of the bracelet and loop it like you did in step two. Put a jump ring on the loop. Once you have the jump rings on securely, add the spring ring clasps onto the jump rings. The spring rings may need to be inserted through the jump rings before closing the jump rings. This can easily be done with pliers. Once the bracelet is complete you can put it on.
Source...