How to Make a White European Deer Skull Mount
- 1). Clean the skull, removing as much flesh as possible. Use a utility knife to remove the skin and muscle, and pliers and a screwdriver to remove any matter from difficult to reach crevices.
- 2). Prepare a pot of boiling water with the water level lower than the height of the skull. It is important the antlers remain above water when placed in the pot.
- 3). Add the bleach to the water as it heats.
- 4). Ladle water over the top of the skull, which sits out of the water, every few minutes. Make certain the antlers remain dry.
- 5). Remove the skull from the water after an hour.
- 6). Clean the skull again after boiling has loosened more flesh from the skull.
- 7). Fill a second pot with hydrogen peroxide equal to the amount of water in the boiling pot. Place the skull in the pot and let it soak about an hour. Ladle the hydrogen peroxide over the skull during this time. Do not allow the liquid to touch the antlers.
- 8). Remove the skull and clean it using the same tools as in Step 1.
- 9). Repeat the process using boiling hydrogen peroxide until the skull is fully bleached and cleaned.
Source...