How Do You Hang a Wedding Cake Upside Down?
- 1). Purchase an aluminum or steel wedding cake support system or make one yourself. The support system needs metal cake base plates and posts with internal threads for securing the posts. The system must be metal as it has to support the wedding cake in air. The number of plates needed corresponds to the number of cake layers. The plates vary in size as the layers generally decrease in size from bottom to top. However, the upside down cake increases in size from bottom to top.
- 2). Screw a post from the wedding cake support system into the center hole of the smallest base plate. The posts are generally made of aluminum or steel and are different lengths for differently sized cake layers. They connect each of the cake base plates together and act as support for the heavy layers of cake. This first base plate and post will serve as the bottom of your cake.
- 3). Slide the smallest cake layer down on top of the post; the cake will slide onto the post easily.
- 4). Press the cake firmly against the base plate and wipe around the edges of the post. The top of your post should stick out of the top of this first layer of cake by 1 inch or so.
- 5). Place the next largest base plate over the post.
- 6). Secure the next post on top of the first by turning it clockwise to secure the thread.
- 7). Slide the second tier of cake onto the post, positioning it firmly onto the plate. Repeat these steps with all of the layers of the wedding cake, up to the final and largest layer.
- 8). Connect a hanging bolt into the top of the final post by turning it into the screw thread clockwise.
- 9). Finish decorating the cake.
- 10
Install a ceiling hook into the ceiling where you want to place the upside down wedding cake with your drill. Use heavy duty screws and a power drill to secure the hook into a ceiling. If you want the cake to hang closer to the table, run a sturdy steel link chain from the hook to the hanging bolt. It's probably best to only have the cake hanging a few inches above the table.
Source...