How to Configure D-Link DSL G604T
- 1
An Ethernet cable.ethernet cable 4 image by BlueMiniu from Fotolia.com
Connect the Ethernet cable to the Ethernet port on the back of the DSL modem and plug the other end into an Ethernet port on your computer. - 2). Open an Internet browser and enter "http://10.1.1.1" into the address bar.
- 3). Enter "admin" as the user name and password. Click "OK."
- 4). Click the "Run wizard" button, then click "Next."
- 5). Enter a password in the "New Password" field that is hard to guess but easy for you to remember. Repeat it in the "Verify Password" box and click "Next." This is the password you will use to log in to the router's configuration page in the future.
- 6). Choose your time zone from the drop-down menu on the next screen and click "Next."
- 7). Select "PPPoE" or PPPoA" from the connection type drop-down menu on the next screen. Your Internet service provider should have told you what type of connection to select.
- 8). Enter the username and password for your Internet account you got from your Internet service provider when you signed up. Click "Next."
- 9). Check the "Enable Wireless LAN" box if you want to use a wireless network, then click "Next."
- 10
Enter the name you want your wireless network to have in the "SSID" box and select a channel from the "Channel" drop-down menu. If you are unsure which channel to use, use the default channel. - 11
Check the "Shared Key" button in the "Authentication" line and the "Enabled" button in the "WEP" line to enable wireless security on your network. - 12
Enter another password that is easy to remember but hard to guess in the password box. This is the password computers will use to log in to the wireless network. Click "Next." - 13
Click the "Restart" button in the "Setup Completed" window to save and apply your settings. When the screen says "The device has rebooted successfully" your D-Link G604T has been successfully configured.
Source...