How to Connect a 6x9 Speaker in a 1992 Toyota MR2
- 1). Unplug the old speaker from the connector on the back of the speaker. Grasp the connector, push in on the tab on the side and pull the connector off.
- 2). Cut off the connector from the wires it is connected to with a set of wire cutters. Cut as close as possible to the connector to preserve as much wire length as you can.
- 3). Remove 1/2 inch of insulation from the ends of the wires with a set of wire strippers.
- 4). Slide the round, cylindrical end of a slide connector over the bare end of one of the wires. Place the jaws of the crimp tool over the slide connector and wire junction and press the handles to crimp the connector onto the wire. Repeat this sequence with the other wire and a second slide connector.
- 5). Slide the flat end of the slide connectors onto the terminal tabs of the new 6x9 speakers--one slide connector to each tab.
Source...