How to Program a Nissan Remote
- 1
Driver's Power Lock
Get in the driver seat and close all the doors. Lock all the doors using the driver's side power lock/unlock switch. - 2). Insert the key into the ignition and remove it from ignition six times or more within 10 seconds. Make sure you remove it from the ignition cylinder fully each time. *If you remove it too fast, the system will not enter the programming mode.
The hazard lamps will begin to flash if you followed the procedure correctly. - 3). Once the system enters the programming mode, insert the key into the ignition cylinder once again and turn to the ON position without starting the car.
- 4). Within 5 seconds, push any button only once on the remote transmitter. Your hazard lamps should flash. If you push the button more than once, the procedure will not work.
- 5). If you are programming more than one remote, including the old ones, unlock then lock all the doors again using the driver's side power lock/unlock switch and within 5 seconds, push any button on the next remote. Hazard lamps will flash.
- 6). Repeat this step for each remote.
Turn the key to the OFF position and remove the key from the ignition, unlock the doors using the driver's side power lock/unlock and open the driver side door.
Source...