How to Program a Cadillac Garage Door Opener
- 1). Turn your vehicle off and press and hold the two outside buttons on the car's garage door opener. This will reset any previous or factory codes on the transmitter.
- 2). Hold your remote garage opener about 2 inches from the system in your Cadillac.
- 3). Press and hold the button you wish to program on your Cadillac system and the open button on your remote at the same time.
- 4). Release both buttons when the red indicator light on the Cadillac system begins to blink rapidly.
- 5). Press and hold the Homelink training button on your Cadillac system to finish programming. If the light remains solid, you're done. If it continues blinking, continue with the following steps.
- 6). Press the "smart" button on your garage door motor. This is usually located near the antenna wire on the back of the unit.
- 7). Press and hold the Homelink button on your Cadillac system within 30 seconds of pressing the "smart" button.
- 8). Release the button after 3 seconds and the indicator light should blink solid. If not, repeat this step up to three times until the light is solid and the programming is complete.
Source...