Doing a Fish Tank Set Up
Doing a fish tank set up correctly the first time will save you of many future problems.
This set up is used for goldfish aquariums because goldfish are very dirty and it is a bit harder to maintain a high quality water for your pets.
Before you buy the aquarium you want you need to decide where you want to place it.
It will be very hard to move it later once it has been set up.
You have to take the measurements of the area where you want to place the tank and compare it with the size of the tank you want.
If the tank comes with a stand included you should measure that too and if not you can buy one or make one yourself.
It is best to have more space so that you do not have problems with the tank not fitting.
The best and recommended place to put your aquarium is the office, the kitchen or the lounge area.
It is not a very good idea to place the tank in your bedroom.
The noise of the water pump could disturb your sleeping.
The same applies if you have kids.
Some parents stop the water pump at night for their kids without knowing that the water will become toxic for the fish.
Doing the fish tank set up So you have the tank in place and everything is OK.
First you need to wipe the dust from your tank.
Wash the gravel 5 times and remove any debris that are floating.
You need at least 2 inches of gravel to become a substrate.
Next you will fill op the tank with cold tap water.
This will take a while, but it will be the only time you will fill the tank.
Now you need to add the water conditioner and the biological supplement for healthy bacteria.
Before you plug in the pump and filter make shore you have a "drip loop".
You have a "drip loop" when the will drop beneath where the plug is.
This way you make shore that any water going down the wire ends up on the floor and not in the plug.
The tank must be set up at least 5 days before you add the fish.
This way you make shore the pump is working, the water is oxygenated and the filter to be populated with healthy bacteria.
If everything is working correctly and you have no leaks you can add the fish to the tank.
Things you do in the first few days The following steps you will do after you add the fish to the aquarium.
It is essential for the safety of your fish to do a 20% daily water change for the first 2 weeks.
This way you will have a correctly working Nitrogen Cycle.
After the 2 weeks do the water changes once a week.
You should clean the sponge filter only once a month.
This way the healthy bacterial will break down the ammonia in your tank.
Depending on what kind of fish you want to add to the tank you will place the right ornaments.
Some fish like the Bubble Eye goldfish or Black Moor can get their eyes hurt in pointed or sharp ornaments.
It is very important to note that.
Adding a plant to your tank will make your aquarium look more attractive and also helps the fish.
This set up is used for goldfish aquariums because goldfish are very dirty and it is a bit harder to maintain a high quality water for your pets.
Before you buy the aquarium you want you need to decide where you want to place it.
It will be very hard to move it later once it has been set up.
You have to take the measurements of the area where you want to place the tank and compare it with the size of the tank you want.
If the tank comes with a stand included you should measure that too and if not you can buy one or make one yourself.
It is best to have more space so that you do not have problems with the tank not fitting.
The best and recommended place to put your aquarium is the office, the kitchen or the lounge area.
It is not a very good idea to place the tank in your bedroom.
The noise of the water pump could disturb your sleeping.
The same applies if you have kids.
Some parents stop the water pump at night for their kids without knowing that the water will become toxic for the fish.
Doing the fish tank set up So you have the tank in place and everything is OK.
First you need to wipe the dust from your tank.
Wash the gravel 5 times and remove any debris that are floating.
You need at least 2 inches of gravel to become a substrate.
Next you will fill op the tank with cold tap water.
This will take a while, but it will be the only time you will fill the tank.
Now you need to add the water conditioner and the biological supplement for healthy bacteria.
Before you plug in the pump and filter make shore you have a "drip loop".
You have a "drip loop" when the will drop beneath where the plug is.
This way you make shore that any water going down the wire ends up on the floor and not in the plug.
The tank must be set up at least 5 days before you add the fish.
This way you make shore the pump is working, the water is oxygenated and the filter to be populated with healthy bacteria.
If everything is working correctly and you have no leaks you can add the fish to the tank.
Things you do in the first few days The following steps you will do after you add the fish to the aquarium.
It is essential for the safety of your fish to do a 20% daily water change for the first 2 weeks.
This way you will have a correctly working Nitrogen Cycle.
After the 2 weeks do the water changes once a week.
You should clean the sponge filter only once a month.
This way the healthy bacterial will break down the ammonia in your tank.
Depending on what kind of fish you want to add to the tank you will place the right ornaments.
Some fish like the Bubble Eye goldfish or Black Moor can get their eyes hurt in pointed or sharp ornaments.
It is very important to note that.
Adding a plant to your tank will make your aquarium look more attractive and also helps the fish.
Source...