How to Troubleshoot a Primos 250-Yard Light
- 1). Insert the 30 mm scope tube adaptor ring into the one inch scope tube mount on the bottom of the Primos light. Position the adaptor so it lines up with the one inch scope tube mount. Snap the light clamp onto the tube of a 30 mm scope.
- 2). Remove the Velcro strip that holds the light pressure switch in place on the grip of the rifle. Position the switch in a location that is easy to reach and activate. Secure the Velcro around the grip of the rifle so the switch does not move excessively.
- 3). Loosen and remove the screws to either side on light housing of the Primos light with a screwdriver. Pull the front of the housing off the light. Loosen and remove the two screws holding the light assembly in place. Remove the wire nut holding the bulb wires in place.
- 4). Replace the bulb and connect the bulb wire to the light wire with the wire nut. Secure the bulb with the two screws that were removed. Place the front of the housing on the light, line up the screw holes and secure the housing with the screws that you removed. Tighten all screws with a screwdriver.
- 5). Plug the charger into a 110 volt wall outlet. Securely insert the charging cord into the battery pack. Charge the battery pack for at least 20 hours before using the battery pack to power the Primos light for the first time.
Source...