How to Charge a Deep Cycle Battery From a Generator
- 1). Inspect your deep cycle battery. Fill non-sealed batteries with distilled water to the full mark inside each battery cell. Remove any spilled acid or corrosion from the top of the battery.
- 2). Fill the generator with gasoline. Check the oil level in the generator according to the manufacturer's instructions. Start the generator and allow it to warm up.
- 3). Attach the battery charger alligator clips to the battery terminals. Attach the red charger clip to the positive terminal on the battery. Attach the black clip to the negative terminal on the battery. The positive terminal is indicated by a plus sign on the battery next to the terminal, and the negative terminal is indicated by a minus sign. Use a three-stage battery charger to provide a higher charge rate for depleted batteries, a medium-rate charge for slightly discharged batteries, and a float charge to maintain proper voltage for charged batteries.
- 4). Plug the battery charger into the generator's 120 volt outlet. Confirm that the battery charger is operating by inspecting its charger condition light. Review the battery charger instructions for descriptions of the lights or gauges showing the status of the battery charger.
- 5). Inspect the deep cycle battery liquid level periodically, and add distilled water as needed. Do not allow the liquid level to drop below the top of the battery plates, as this will damage the battery and cause overheating.
Source...