From Seriously Straight to Curly Cute

• 1). Roll the synthetic hair very tightly in small sections onto rollers. Be sure to pin the curls in place so they will not fall out until you are ready to remove them.
  
  
• 2). Pour hot water (160 to 185 degrees) over the rollers. Do not make the water too hot or it will damage the synthetic hair. (This is not human hair, so you have to be more careful.)
  
  
• 3). Let the hair air dry for about 15 minutes. When 15 minutes are up, dry the rolled hair on the lowest setting on your blow dryer.
  
  
• 4). Use wig spray on the rollers and blow dry again on low heat.
  
  
• 5). Carefully remove the rollers when the hair feels dry to the touch. Remove the rollers in a downward motion and hair will form ringlets. For looser curls or waves, gently run your fingers through the curls. Spray the wig with wig spray to set.