How to Install a Vacu-Hold Boat Cover
- 1). Pull the cover onto the personal watercraft, over the handlebars and mirrors, starting at the bow, ensuring the cover fits under the front of the bow and pulling the cover back toward the stern.
- 2). Pull the cover over the back of the rear of the watercraft, one side at a time.
- 3). Find the knot in the elastic cords at the front of the cover. Pull the knot and the elastic cords as far away from the bow of the boat as possible. Tie a knot in the cord as close to the bow of the boat as you can. The knot must be large enough that it will not pass through the sewn edge of the cover.
- 4). Attempt to lift and reinstall the cover on the rear of the boat. If you are able to do so, pull the elastic cords tighter. After the cords are adjusted to the proper length, cut the excess cord off with scissors and sear the end of the cords with a cigarette lighter.
Source...