How to Replace a Headlight for a Sedona
- 1). Open and support the hood. Find the three bolts that keep the headlight mounted in place. One bolt is on the top-outboard corner. The other two bolts are in the front-inboard corner, close to the center of the grille.
- 2). Remove each bolt with a 10mm socket wrench. If the bolts are difficult to remove, spray them with a bolt lubricant such as Liquid Wrench or PB Busters.
- 3). Attempt to pull the headlight out. Start in the inboard corner. There is an additional stud between the mounting frame and the headlight. If you cannot pull the headlight out with your hands, use a large flat-head screwdriver to push outward against the rear of the headlight. This should release it from the stud.
- 4). Unplug the harness from the back of the headlight. Bring the headlight to a table or work station.
- 5). Twist off the plastic cap to view the bulb. Squeeze the outer tabs on the bulb socket and pull it out. Insert the new bulb in its place, holding it by the metal trim on the bottom. Avoid touching the glass. If necessary, wear gloves. The tabs will lock to secure the bulb.
- 6). Bring the headlight back to the Sedona. Attach the wiring harness to the rear. Re-insert the headlight into its mount. Push it firmly to re-engage the stud. Tighten the three 10mm bolts.
Source...