How to Make Switch Plate Covers
- 1). Lay the switch plate over the wallpaper or fabric.
- 2). Using the X-Acto knife or scissors, cut the wallpaper or fabric about ½ inch larger than the switch plate.
- 3). Spray or brush adhesive on the back of the wallpaper or fabric.
- 4). Place the wallpaper or fabric over the switch plate and smooth. Allow it to dry.
- 5). Fold the excess wallpaper or fabric to the back of the switch plate and tape it in place.
- 6). With an X-Acto knife, cut an X in the fabric where the switch hole is located. Fold the edges back through the switch hole and tape them to the back of the switch plate.
- 7). Punch the screw holes with a small Philips screwdriver.
Source...