How to Install Fog Lights on a 2000 Chevrolet Monte Carlo LS
- 1). Open the driver's door on your Monte Carlo LS and apply the emergency brake.
- 2). Raise the car on the driver's side near the front tire with a hydraulic jack. Place a jack stand beneath the frame rail two inches away from the hydraulic jack. Lift the support arm on the jack stand until it makes contact with the frame rail.
- 3). Lower the hydraulic jack slightly until the car rests on the jack stand's support arm. Don't remove the hydraulic jack or completely lower it. Leave it in place for extra support.
- 4). Slide under the front end of the car on the driver's side so that you're able to clearly see the rear of the fog light.
- 5). Remove the two nuts on the back of the fog light assembly with a socket wrench. Push the fog light forward, out of the front bumper. The wiring harness connected to the fog light doesn't provide that much slack, so try not to use too much force.
- 6). Slide from beneath the car and position yourself directly in front of the fog light. If you look through the side of the fog light assembly, you should be able to clearly see the wiring harness plugged into the back of the bulb.
- 7). Lift the wiring harnesses safety clip by inserting a flat-head screwdriver under the clip until it rises up. Leave the screwdriver in position temporarily. Hold the fog light assembly in one hand. Unplug the wiring harness with your other hand. Do not directly pull on the harness wires--instead remove the harness by its plug. The screwdriver will simply fall onto the ground once you completely remove the harness plug from the fog light bulb.
- 8). Install the new fog light on your 2000 Chevrolet Monte Carlo LS by completely reversing all of the removal steps. You won't need the flat-head screwdriver; just plug the harness back up to the fog light bulb by hand and it clicks into position.
Source...