How to Use a Partial Capo
- 1). Tune your guitar to EADGBE. This is the standard tuning used for a six-string acoustic or electric guitar.
- 2). Turn the capo around so it will be in the right position when you clip it to the guitar. The rubber edge presses against the strings.
- 3). Press the lever of the capo together so that the two edges of the clip are spread, then put it around the neck of the guitar. Place the rubber edge on top of the strings, in the middle of the space between frets. Release the lever and the capo holds in place.
- 4). Maneuver the capo up and down the fret board to change the sound of the chord. A partial capo only presses across three or four strings. For example, position it on the second fret covering the second, third and fourth string. This creates DADGAD tuning.
- 5). Strum the guitar strings and listen to how the partial capo changes the tone. Then, play a selection of chords and listen to the sounds. Experiment with where you position the capo to change the sound of the chords you play.
Source...