How to Troubleshoot a ViewSonic Projector
- 1). Remove the lens cover. It's surprisingly easy to forget. Check for obstructions between the lens and the projection screen.
- 2). Check the power connection. Unplug and reconnect both ends of the projector's power cord; do the same with any power bars or surge protectors the projector is plugged into.
- 3). Wait until the projector has finished cooling down before attempting to turn it on again. Quickly cooling then reheating the projector's lamp dramatically reduces lamp life.
- 4). Check the projector's video connections and cables. Unplug both ends of any video cables attached to the projector and reconnect them. If your projector is connected to a computer, make sure the computer is producing a video signal that is compatible with the projector; most video cards are capable of producing higher-resolution images than most projectors support.
- 5). Set the projector to the correct video input source. Press the "Resync" button, if your model has one, to correct image flickering or instability. You can adjust other image settings using the projector's menus. Try adjusting "Frequency" and "Tracking" under "Computer Image."
- 6). Adjust the focus of the image if the picture is blurry. The focus ring is located around the lens array.
- 7). Stay within 6 meters of the projector when using the remote; it won't work any further away. Also, the remote uses an infrared beam to communicate with the projector; this beam is blocked by obstructions. If the remote still doesn't work, change the batteries.
- 8). Check your lamp's play time; some projectors turn themselves off automatically once their lamp has a certain number of hours of use logged. Spent lamps should be replaced before attempting to use the projector again.
Source...