How to Solder 30 Gauge Wire to a 0603 LED
- 1). Cut the 30-gauge wire into two separate strands using the wire cutter. Split the wire in two separate strands, one for the anode and other for the cathode terminal of the LED. Mark one strand using a permanent marker for the anode terminal. Strip one end of each wire using the wire wrap tool or the wire stripper.
- 2). Apply a small amount of solder flux using a small brush on the two LED terminals and on the wire tips.
- 3). Heat the soldering iron to a temperature of 660 degrees Fahrenheit. Load some solder onto the soldering iron tip. While holding the LED with the tweezers, touch the soldering iron tip to each of its terminals so that the solder flows onto the terminals.
- 4). Hold the LED in position using the tweezers and wrap the 30-gauge wire strands around its terminals by preparing a small loop of wire ends. Touch the soldering iron tip on the solder on the LED terminals until the solder flows to form a bond between wire ends and the terminals.
- 5). Using a magnifying glass, observe the bond between the wire ends and LED terminals. If they are not bonded properly, detach the wires from LED by touching the soldering iron tip to the solder on the bond and sucking the molten solder off with the solder sucker. Repeat the soldering steps to attach the wires to LED terminals.
- 6). Connect battery terminals to the other ends of wires and ensure that the LED turns on. If the LED does not turn on, it is possible that the LED may have been damaged due to exposure to excessive heat during the soldering process. In that case, repeat the procedure using a new LED.
Source...