How to Repair Motorcycle Handlebar Grips
- 1). Remove brush guards from your handlebars (if applicable), as these will only hinder the process. Use the plastic syringe to suck up some of the rubbing alcohol. Insert the needle underneath of the handlebar grip and slowly squeeze the alcohol into the grip.
- 2). Allow the alcohol to work its way under the grip for a few minutes and then begin slowly twisting the grip back and forth on the handlebar. It may take a few minutes, but eventually this twisting motion will work the alcohol around and loosen the grip from the bar. While working the grip back and forth, pull away from the handlebars to help slide the grip off of the bar.
- 3). Thoroughly clean the handlebar using the alcohol and a rag and then install the new grip according to the manufacturer's instructions (normally just the reverse of Steps 1 and 2). For extra security, cut a piece of the stainless steel wire long enough to wrap around the grip and handlebar at the end. Use the pliers to twist the ends of the wire together, firmly mounting the handgrip in place.
- 4). Repeat Steps 1-3 for the other hand grip and then replace your brushguards or other accessories. Allow the new handgrips to dry for 8 to 12 hours before use.
Source...