Air-O-Swiss Directions
- 1). Place your Air-O-Swiss unit on a flat level surface that is at least 3 feet from the ground and within reach of a working electrical outlet.
- 2). Unscrew the demineralization cartridge that is in the center of the unit, and soak it in water for 24 hours before the initial use of the unit.
- 3). Replace the demineralization cartridge and fill the water tank with cold tap water. Cover the water tank with the cover so that it is securely on top of the tank.
- 4). Plug the AC adapter into the working electrical socket and turn the ON/OFF switch to ON. Watch the light that indicates the fact that there is water in the tank. It may remain on for a minute or two after you start the unit. It should go off within two minutes.
- 5). Use the dial on the right as you face the unit to adjust the setting, depending on how high you wish the mist coming out of the unit to be.
- 6). Adjust the level of humidity by turning the dial on the left-hand side of the unit as you face it to a level with which you are comfortable. It may take a few adjustments to get the exact setting comfortable for you.
- 7). Locate the button on the bottom of the front of the unit. This is the preheating element. This takes about 15 minutes to activate, but the water will come out of the unit at 104 degrees F. Once the water has reached the right temperature, the light on the right-hand side will turn on.
- 8). Check the light next to the preheating light. This indicates when it is time to add more water to the unit.
Source...