How to Remove the Dash on a 1994 Toyota Pickup
- 1). Pop up the hood and remove the negative battery cable with a wrench.
. - 2). Open the fuse panel cover on the driver's side dash and locate the airbag fuses on the diagram located on the inside panel door. Remove the fuse puller from inside the panel and use it to remove the SRS fuses. Wait about 30 minutes.
- 3). Locate a bolt on the bottom left corner of the driver's side knee bolster and remove it with a socket wrench. Find two screws on either side of the steering column and remove it with a Phillips screwdriver. Find the screw on the bottom right corner of the driver's side knee bolster and remove it with a Phillips screwdriver. Pull off the knee bolster and unplug the wiring behind it and slide it out the driver's door.
- 4). Remove the bolt from below the right side of the glove box using a socket wrench. Remove the screw from under the left side of the glove box. Open up the glove box and remove the screws with a Phillips screwdriver. Pull out the glove box and unplug any wiring behind it.
- 5). Locate the bezel in the center of the dashboard. Remove the screw from the bezel with a Phillips screwdriver. Pull off the A/C knobs. Pull the cup holder out and remove the lighter.
- 6). Wedge the trim removal tool under the center bezel and pry up on the bezel and pull it forward. Reach behind it and unplug all wiring. Pull the center dash up and out the passenger's side door.
Source...