How to Build a DIY Rubber Playground Surface
- 1). Level the ground for the entire area of the intended playground. For every 10 feet away from the house, the grade should drop 1 inch. This will allow for proper drainage. Drainage is a critical design consideration for installation of a playground. Improper drainage could cause potential hazards under certain weather conditions.
- 2). Install the playground border or edging, and place the playground equipment in the desired configuration.
- 3). Cut the landscaping cloth or fabric to fit around the playground equipment and/or trees and shrubs. Cover the entire playground area, properly securing the landscaping cloth with tape, staples or liquid nails. This will prevent it from pulling away and will discourage weed growth.
- 4). Lay rubber mats in high traffic areas (at the bottom of slides or underneath swings) and distribute the rubber mulch evenly over the entire area of the playground. According to JJV Rubber Mulch and Safety Surfacing, Inc., the mulch should be at least 4 inches deep. Consideration should be given to the height of the equipment that has been installed. Taller equipment requires more mulch to properly cushion a fall.
Source...