1.6-Liter Spectra

• 1). Disconnect the negative battery terminal using a hand wrench. Lift the car up on the car lift to gain access to the starter. Put on the safety glasses before going underneath the Spectra.
  
  
• 2). Use the ratchet and a socket to remove the four intake manifold stay bracket bolts. Remove the bracket.
  
  
• 3). Disconnect the electrical connections from the starter using the ratchet and a socket.
  
  
• 4). Remove the two upper starter bolts using the ratchet and a socket.
  
  
• 5). Remove the lower starter bolt using the ratchet and a socket, and then remove the starter. To install, reverse the procedure.
  
  

1.8-Liter Spectra

• 1). Disconnect the negative battery terminal using a hand wrench. Lift the car up on the car lift to gain access to the starter. Put on the safety glasses before going underneath the Spectra.
  
  
• 2). Spray the exhaust pipe (below the starter) connections with a liberal amount of penetrating lubricant and allow to soak. Apply more lubricant spray to the connections between the next three Steps.
  
  
• 3). Remove the two upper intake manifold support bracket bolts using the ratchet and a socket.
  
  
• 4). Disconnect the electrical connections from the starter using the ratchet and a socket.
  
  
• 5). Remove the two upper starter bolts.
  
  
• 6). Disconnect the exhaust pipe nuts and bolts. Use a wrench to hold the head of the bolt stationary while using the ratchet and a socket to remove the nuts. Remove the exhaust pipe.
  
  
• 7). Remove the lower intake manifold support bracket bolts using the ratchet and a socket, then remove the bracket.
  
  
• 8). Remove the lower starter bolt using the ratchet and a socket and then remove the starter. To install, reverse the procedure.
  
  

2.0-Liter Spectra

• 1). Disconnect the negative battery terminal using a hand wrench. Lift the car up on the car lift to gain access to the starter. Put on the safety glasses before going underneath the Spectra.
  
  
• 2). Disconnect the starter cable from the "B" terminal using a ratchet and a socket.
  
  
• 3). Remove the connector from the "S" terminal.
  
  
• 4). Remove the two starter bolts using a ratchet and a socket, then remove the starter.
  
  
• 5). Reverse the procedure to install.