How Do You Replace the Belt on a Hoover Turbo Cyclonic
- 1). Step on the handle release lever at the base of the vacuum cleaner. Lower the handle to the floor.
- 2). Turn the unit over. Remove the three screws on the bottom of the base cover.
- 3). Turn the unit right side up. Pull the base cover up to remove it.
- 4). Lift the brush roll out of the base. Slide the old belt off of the roll.
- 5). Position the new belt around the motor shaft. Insert the brush roll into the other end of the belt. Position the belt within the groove on the brush roll.
- 6). Pull and slide the brush roll into the base assembly. Rotate the brush roll by hand to make sure the belt is aligned properly.
- 7). Replace the base cover. Turn the vacuum cleaner over. Install the three screws that hold the base cover in place.
Source...